Standard Delivery; Special Accessories; Installation; Place Of Installation - Stiebel Eltron SBP 200 E Utilisation Et Installation

installation

installation
D imensions SBP 700 E | SBP 700 E SOL
12 Thermal insulation
13 Heating flow
14 Heat pump flow
15 Thermal insulation sections
16 Flow, solar indirect coil (only SBP 700 E SOL)
17 Heating return
18 Heat pump return
19 Return, solar indirect coil (only SBP 700 E SOL)
5.3 Standard delivery
The standard delivery includes the following parts, packed in a
separate bag.
— Operating and installation instructions
— Detachable bezel for connecting lines
— Adjustable feet (only with SBP 200 E | SBP 400 E)
5.4 Special accessories
Description
BGC immersion heater
WPKI 5 compact installation
WPKI 6 compact installation
6. Installation
6.1 Place of installation
»
Ensure the floor has a sufficient load bearing capacity (see
Specification table).
»
Check the height of the room (see Specification table).
www.stiebel-eltron.com

6.2 transport

!
12
13
6.2.1 Removing the cylinder casing
14
R emoving the cylinder casing
15
16
17
18
19
1 Lid
2 Cylinder casing
3 Plinth fascia
»
First remove the lid and then the plinth fascia.
6.2.2 SBP 700 E | SBP 700 E SOL
These appliances have side insulation sections that can be
removed. This will make transportation through narrow doors
and passageways easier.
»
Remove the retaining straps by opening the closures.
Part no. When reattaching the retaining straps, ensure that the closures
075115
are near a joint between the casing parts.
220830
220831

6.3 Positioning

6.3.1 SBP 200 | SBP 400
»
Fit the adjustable feet provided, these are already fitted on SBP
E cool appliances.
»
Use the adjustable feet to compensate for any unevenness in
the floor.
6.3.2 SBP 700
These appliances do not have adjustable feet. The floor must
be level.
Risk of damage
We recommend removing the cylinder casing during
transportation to the installation location.
sBp e | sBp e sol | sBp e cool |
1
2
3
13