Panasonic CS-E18NKUA Instructions D'utilisation page 10

INFORMATION
FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE
• Check remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling/Heating operation.
After 15 minutes of operation, it is normal to have the following
temperature difference between air inlet and air outlet vents:
Cooling: ≥ 14.4°F/8°C
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours to remove moisture left in the
internal parts thoroughly to prevent mould growth.
• Switch off power at the circuit breaker.
• Remove the remote control batteries.
Information for Users on Collection and Disposal of Old Equipment and used Batteries
Pb
Contact your local hazardous waste disposal hotline.
Models Number
The above listed models have been designed and manufactured to meet ENERGY STAR
energy effi ciency when matched with appropriate coil components. However, proper refrigerant charge
and proper air fl ow are critical to achieve rated capacity and effi ciency. Installation of this product should
follow the manufacturer's refrigerant charging and airfl ow instructions. Failure to confi rm proper charge and
airfl ow may reduce energy effi ciency and shorten equipment life.
Federal Communications Commission Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, follow the attached installation instructions. Any changes or modifi cations
not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
Industry Canada Notice
This Class B digital apparatus complies with Canadian ICES-003.
10
Heating: ≥ 25.2°F/14°C
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please
contact your local authorities or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with
the requirement set by the Directive for the chemical involved.
CS-E18NKUA / CU-E18NKUA only.
NON SERVICEABLE CRITERIAS
SWITCH OFF POWER AT THE CIRCUIT
BREAKER then please consult an authorized
dealer under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote
control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Switches or buttons are not functioning properly.
criteria for
®