Basic Operations; Before Operation - JVC XV-S500BK Manuel D'instructions

Basic operations

In the following description, we assume that the buttons on the remote control unit are mainly used, however, you may
use the corresponding buttons on the front panel if available.
NOTE
Make sure that the TV - DVD switch on the remote control unit is set to "DVD" when using the 5/∞/2/3 and
numeric buttons for controlling the unit.
TV DVD

Before operation

Turning on/off the unit
Press DVD STANDBY/ON
The STANDBY indicator on the front panel, which illuminates in red during standby, goes off.
OPEN/
CLOSE
TV1
1
TV4
4
TV7
7
TV-/--
10
RETURN SUBTITLE
CH
+
VOL-
ENTER
CH
-
PREVIOUS
CLEAR SELECT
SLOW-
REPEAT SUBTITLE
DIGEST ANGLE
3D
PHONIC
RM-SXV008J
REMOTE CONTROL
• You can turn on the unit by pressing the
If no disc is set, "NO DISC" appears on the display window.
• You can turn on the unit by pressing the 0 OPEN/CLOSE button on the front panel. In this case, the disc tray opens.
The opening display shown right appears on the TV screen.
The following message may appear at the bottom of the opening display
depending on the condition.
• NOW READING:The unit is reading the disc information.
• REGION CODE ERROR!:
• OPEN:
• CLOSE:
• NO DISC:
NOTE
• Even if you press the DVD STANDBY/ON
unit, the unit is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called the
standby mode. In this state, the unit consumes a very small amount of power.
12
on the remote control unit or press STANDBY/ON
TV DVD
STANDBY/ON
TV DVD
DVD
TV2 TV3
2 3 STANDBY/ON
TV5 TV6
5 6
TV8 TV9
8 9
TV0 MUTING
0 +10
TITLE/ TV/VIDEO
GROUP CANCEL
VOL+
NEXT
STROBE
SLOW+
AUDIO VFP
PROGRESSSIVE
SCAN
ZOOM
AMP VOL
3
button. In this case, the unit starts playback if the disc is set in the disc tray.
The region code of the DVD VIDEO disc does not
match the unit. The disc cannot be played back.
The disc tray is opening.
The disc tray is closing.
No disc is loaded.
on the remote control unit or STANDBY/ON
STANDBY/ON
STANDBY
STANDBY/ON
STANDBY indicator
on the front panel.
DVD/SUPER VCD/VCD/CD PLAYER
NOW READING
Message area
on the front panel to turn off the
0
OPEN
PROGR