Publicité
Les langues disponibles
Les langues disponibles
› Average (sensitivity is calibrated between the two previous
levels for all intermediate cases). The is also the default
setting.
To change collar sensitivity, hold down buttons
(based on the selected collar) and button
control for about 2 seconds to turn on High sensitivity, button
for Average, button
for Low.
If successfully set, two confirmation beeps will sound (we sug-
gest these changes be made with the dog nearby).
COLLAR TONE SELECTION
Use button
to change the tone on the collar selecting from
the six different tones.
Press this button to scroll tones one at a time. Each time the
button is pressed, the tone will change and the last tone heard
will be set as "on". No further confirmation is required.
This function is not subject to other settings so that tones can
be scrolled even when the collar is in "silent" mode.
Attention: if you change the cap, you must remember to chan-
ge also the correct sound group, otherwise you will not have
the best audio performance.
According to the type of cap you are using (taller or shorter),
you must choose the correct group of sound:
With the beeper and the remote unit switched on, press
or
+
buttons together on the remote to change the
sound group suitable for the shorter cap. Press again the
same button to go back to the taller cap.
By default, the sound group suitable for the taller cap is
activated.
COLLAR VOLUME
Use button
to adjust collar volume selecting from the three
settings (low - medium - high). Hold the button down to scroll
options. Collar tone will be reproduced to hear the level. Re-
lease the button to set the last level heard as "on".
This function is not subject to other settings so that the three
options can be scrolled even when the collar is in "silent"
mode.
14
REMOTE CONTROL WARNINGS
Use button
remote control.
Press the button to scroll the four available options. The op-
or
tion to be selected will be reproduced on the remote control
on the remote
each time the button is pressed, followed by an acoustic sig-
nal to indicate scrolling.
The options are:
› Sound only
› Vibration + Sound
› Vibration only
› Mute
Regardless of the selected option, the led that indicates the
selected dog will always be on (for at least 3 seconds).
to select how warnings are displayed on the
Publicité
