Electrolux FI5004NXA+ Notice D'utilisation page 7

All manuals and user guides at all-guides.com
3.8 Fridge Control panel
1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. Shopping Function light
7. Shopping Function switch
8. Minidac light
9. Minidac switch
3.9 Switching on
1. Insert the plug into the wall socket.
2. Press the ON/OFF switch.
The Pilot Light will light up.
3.10 Switching off
The freezer is shut off by pressing
ON/OFF switch until the Pilot light and
the Temperature indicator switched off.
3.11 Temperature regulation
The temperature can be adjusted
between +2°C and +8°C.
By pressing the Temperature regulators,
the current temperature setting flashes
on the Temperature indicator. It is
possible to modify the setting
temperature only with flashed indicator.
To set a warmer temperature, press
warmest Temperature regulator. To set a
colder temperature, press coldest
Temperature regulator. The Temperature
indicator displays the newly selected
temperature for a few seconds and then
shows again the inside compartment
temperature.
The newly selected-temperature must be
reached after 24 hours.
3.12 Temperature indicator
During normal functioning the
Temperature indicator shows the
temperature inside the freezer.
1 2 3 4 5
The difference between the
temperature displayed and
temperature setting is
normal, especially when:
• a new setting has
recently been selected
• the door has been left
open for a long time
• warm food has been
placed in the
compartment.
3.13 Shopping Function
function
The maximum performance is obtained
by setting the Shopping Function
function. It's recommended when loading
large quantities of food.
You can activate the Shopping Function
function by pressing the Shopping
Function switch.
The Shopping Function light will light up
and the fan automatically will start.
The internal temperature
goes down to +2°C.
After about 6 hours the
Shopping Function function
switches off automatically.
3.14 DAC function (Dynamic Air
Cooling)
You can activate the DAC function by
pressing the Minidac switch.
The Minidac light will light up and the will
be activated.
The function can start automatically if
necessary (refer to " Air recycling")
ENGLISH 7
6 7 8 9