Electrolux FI5004NXA+ Notice D'utilisation page 18

18 www.electrolux.com
10. Then refit the bracket cover.
8.6 Fitting the plinth
Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make
a cut out as shown.
170-220 mm
• If using a plinth higher than 100 mm
but less than 140 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit
it between the plinth and the
ventilation grille, pressing it into
position below this grille.
• If using a 100 mm plinth, fit the
complete height compensation strip.
All manuals and user guides at all-guides.com
3
2
1
820-870 mm
900 mm
140-190 mm
30-100 mm
140-190 mm
1
2
Alignment height of 870 mm
• If using a 190 to 220 mm plinth, make
a cut out as shown.
30-100 mm
• If using a plinth higher than 150 mm
but less than 190 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit
it between the plinth and the
ventilation grille.
• If using a 150 mm plinth, fit the
complete height compensation strip.
• If the appliance is installed at the end
of a row of units, insert foot E to hold
the plinth in place.
3
100-150 mm