Electrolux FI5004NXA+ Notice D'utilisation page 16

16 www.electrolux.com
• 1. Rear edge
• 2. Front edge
• 3. Right hand side panel
The dimension of 260* mm is allowed
for fitting a 100 mm plinth below the
panel. For different plinth sizes,
increase the dimension of 260* mm
accordingly.
2. Apply spacers to the hinges before
installing the appliance into the
cabinet . See picture
2
3. Rest the panels against the
appliance.
4. Fit the rear brackets, taking into
account the thickness of the panels
(maximum width of unit 900 mm).
For a correct alignment make sure
that the distance between the
appliance and the cabinet is of 45
mm.
5. Secure the panels at the front.
All manuals and user guides at all-guides.com
D
1
6. Fix the squares (contained in the
bag) to the lower part of the door
(references already provided).
7. If necessary, door opening angle
max 90° can be obtained by
introducing the pivots supplied
separately. See picture.
D
L
8.5 Fitting the door panels
1. Open a door a remove the bracket
cover. Undo the nuts with washers
and remove the bracket from the
door.
45 mm
2. Drill the small doors as shown in the
figure.
N
L
o
90
o
115
N
2
1
10 mm