Kawasaki K-SSCM 1200 Notice Originale page 20

Troubleshooting
Problem
Machine does not start
Machine does not run smooth-
lyand not true
Cutting power too low
Water cooling too weak
Explanation of the plate
Please read operating instructions.
Caution, risk of cutting.
Wear hearing protection when working with the machine.
Flying splinters pose a risk during the operation of the machine! Therefore, always wear safety
glasses.
Wear good quality, strong gloves.
Used with a continuous rim diamond cutting-o wheel.
20
All manuals and user guides at all-guides.com
Cause
No power
Power cable not connected
Switch defective
Check the cutting disc for
damage
Starting capacitor defective
Motor bearing damaged
Flange on cutting disc loose
Cutting disc not tted cor-
rectly
Diamond edging blunt
The pump is not transpor-
ting enough water
Remedy
Check mains, socket, cable
Replace the switch
Replace the disc
Have it repaired by a dealer
Have the bearing replaced by a
dealer
Tighten it
Check and t correctly
Sharpen with a whet stone
Clean the pump
Add more water