Publicité
Les langues disponibles
Les langues disponibles
pipes, radiators, stoves, and refrigerators, to pre-
vent an electric shock.
Never carry the device by the cable. Only pull
the cable from the receptacle with the plug.
Protect the cable from oil, heat, and sharp edges.
Damaged cables can cause an electric shock.
Check the device and power cable for damage
before starting work.
When plugging in the power plug, make sure that
the operating switch is not located in position.
Only use approved extension cables when using
the device outside.
When using a cable drum, unwind it entirely in
order to prevent the cable from heating up. The
minimum wire gauge is 1.5 mm2.
Pull the plug when you are not using the device
or making adjustments.
Always guide the cable away from the back of the
tool.
Safety instructions for using the stone cutting
machine
- Always place the machine on rm ground where
it is horizontal.
- Always ll the machine with water before star-
ting work.
- Electric cables must not come into contact with
water or water mist.
- Do not use segmented cutting discs.
- Replace damaged blades immediately.
- Ensure that the blade is tted correctly.
- Always use the blade guard when working with
the machine.
- Always wear safety goggles and ear protectors.
- Use only stone cutting discs of the correct size.
Electrical safety
- The increases safety regulations for wet operati-
All manuals and user guides at all-guides.com
on apply to this stone cutting machine. All the
safety measures to prevent contact with increa-
sed voltages are applicable.
- Use a three-core cable H07 RN-F3 3x0.75 to con-
nect the machine to the mains supply.
- Have all electrical connections made only by an
electrician.
- Disconnect the mains plug from the supply
before all maintenance and adjustment work.
Machine components
1. Feet
2. Machine frame/Tank
3. Water drain
4. Workbench/Top section
5. Cutting disc
6. Angle stop
7. Stop rail
8. Guide rail
9. Star handle screw for guide rail
10. Cutting disc guard
11. Handle
12. Star handle screw for angle adjustment
13. Transit guard
14. Cooling water pump
15. Cooling water hose
16. Motor
17. ON/OFF switch
18. Angle scale
19. Wing screws for feet
20. Ring wrench
21. Shaft wrench
22. Sealing stopper
Assembly
Base frame assembly
- Check all the parts for signs of transport damage
before assembly.
- Place all the parts on a at surface.
GB
17
Publicité
