Kawasaki K-SSCM 1200 Notice Originale page 18

- Slide the four feet (1) into the mountings (A) in
the machine frame (2) and secure them using
the wing screws (19) (B4).
- Place the top section of the machine (4) into the
machine frame (2) (B5).
- Seal the base of the tank (2) using the sealing
stopper (22), (A) (B8).
Install the water pump
- Connect the cooling water hose (15) to the
pump (14) (B6) (B7).
- Place the water pump (14) on the base of the
tank (2) using the suction cup (B8) (B).
Ensure that the water hose (15) is not kinked
anywhere.
Working with the stone cutting machine
- Remove the transit guard (13) (B9).
- Fill the tank (2) with water up to approximately 5
mm below the edge of the tank.
Ensure that the power supply has the correct vol-
tage (see rating plate).
(B10)
(B10)
18
All manuals and user guides at all-guides.com
Longitudinal cut
- Set the required cutting length (A-B) using the
Guide the cutting disc slowly and evenly through
Mitre cut
Swing the entire machine head with the cutting
Undo the two side star handles (12), set the
Guide the cutting disc slowly and evenly through
(B10)
Diagonal cut
Clamp the angle stop (6) in the stop rail (7) and
(B2)
(B2)
star handle screws (9) on the machine head
(B12).
the workpiece.
disc for mitre cuts from 90° to 45°.
required angle (18) and tighten the star handles
again (B13).
the workpiece.