It is pointless to set your device to the maximum setting; your room's temperature will not rise any
faster.
All the devices in the same room must be set in the same way.
IF YOU WILL BE ABSENT FOR A PERIOD OF 2 TO 24 HOURS
Set the cursor to
NB : The absence detection sensor also enables you to ensure an automatic reduction in temperature during
your absence (see the section "How to use the energy-saving functions").
IF YOU WILL BE ABSENT FOR A PERIOD
Set the cursor to
LOCKING THE DEVICE'S SETTINGS
Release the device from its hanging frame (see Page 25).
Set the cursor to the desired
position.
PROG
Advice
.
OF MORE THAN 24 HOURS
.
LOCK THE CURSOR
2
Remove one pin from its
holder on the back of the
control box.
Your device will maintain a tempera-
ture approximately 3.5°C lower than
the Comfort temperature you have
set.
PROG
Your device will maintain a tempera-
ture of 7°C ±3°C, corresponding to
the Frost setting.
PROG
3
Now the setting on the control
cursor cannot be altered.
31
Place the locking pin in the
hole opposite the arrow.
Cursor
GB