Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.4 Connection of the stove to the chimney
The stove can be connected directly to the chimney (rear connection).
It's important that all parts of the chimney are fitted airtight.
ATTENTION!
The diameter of the chimney should match the diameter of the flue outlet of the appliance., Please note the
following regarding the diameter of the chimney:
•
The diameter of the chimney may not be reduced. Also, the flue outlet must fit the chimney perfectly.
•
If there is too much chimney draught, then a damper must be incorporated.
•
The chimney may not draw in extra air. Watch out for flue dampers and cleaning hatches in the cellar
or on the roof!
•
The flue outlet must be securely attached to the connector pipe.
7.5
What must I do in the event of a chimney fire?
We recommend that you take the following steps in the event of a chimney fire
1. Close off the air supply.
2. Call the fire brigade.
3. Clear access routes to the cleaning openings (e.g. cellar and attic).
4. Move all inflammable objects away from the chimney.
5. When the appliance is put back into service, the chimney and the stove should be checked over by a
specialist.
6. This specialist should also investigate the cause of the chimney fire after and take any corrective
measures.
SUGGESTION
If you let the fire burn for 10 minutes each day at maximum power, this allows
combustion products to be burnt off. This reduces the risk of any chimney fire and
also helps keep the window cleaner.
7.6 Conversion from top to rear connection
The fire comes standard with a top connection - which can easily be converted to a rear connection.
•
Remove the round back plate from the mantle (break out by moving it back and forth).
•
Remove the cover of the drain opening from the inside of the stove.
•
Remove the bus shelter from the top of the appliance and place it on the connection opening of the
stove. Make sure it is connected properly airtight.
•
Place the cover taken from the rear connection on the duct opening above the appliance. Again, make
sure the connection is airtight.
•
Observe the sealing cap provided at the top of the recess in the casing.
33
Publicité
Table des Matières
