Dust Connection; Mains Connection; Starting Operation - Jet Tools JTS-700S Mode D'emploi

Fig 8
Mounting Sliding Table Mitre
Gauge
Slide the mitre gauge fence (B, Fig. 9)
into the bar (A) and attach to the mitre
gauge body (C) with two handles (D).
Note: the 45° chamfered end (B)
should be pointing at the saw blade.
Fig 9
Place the mitre gauge on the sliding
table.
Place indicator bar (E) on top of the
mitre gauge body and secure in place
with bushings (F), and handles (H).
Slide the square nut (I) into the slot on
top of the fence.
Secure the stop (J) in place with
handle (K).
Use a square to make sure mitre
gauge is 90°/45° to saw blade and
adjust the positive stops (O, P).
Adjust cursor if necessary.
There are 4 possible mounting
positions on the sliding table for the
mitre gauge (see Fig 10 and 11).
Fig 10
Fig 11
A workpiece hold down can be used.
Mounting Sawblade
See chapter 7.1
Mounting Raving Knife
See chapter 7.2
Mounting Saw Guard
See chapter 7.3
7

5.3 Dust connection

Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the saw is
switched on.
A hose, a Y-piece and a hose support
are supplied with the machine.
The flow rate on the suction port dia
100mm must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.

5.4 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16A surge-proof fuse.
Only use connection cables marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
The machine is equipped with a
16Amp CCE Euro plug, mounted at
the back side of the frame.
Attention:
-Check first if the saw spindle runs
freely and if all safety devices are
fitted before starting the machine.
- If the direction of rotation is not
correct, the phase converter inside the
CCE Euro plug must be pushed in and
turned 180°.
(Clockwise direction of the spindle is
correct).
For safety reasons this must only be
done without the sawblade installed!

5.5 Starting operation

You can start the machine with the
green On-button. The red Off-button
stops the machine.
Note:
-When the lower sawblade cover is
open, it is impossible to start up the
machine.