Cleaning The Filter; Cleaning The Brushroll - shark ion RV850C Série Guide D'utilisation

MAINTENANCE

CLEANING THE FILTER

CLEAN FILTER EVERY WEEK.
REPLACE FILTER EVERY TWO MONTHS. See sharkaccessories.com for replacement filters.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove dust and debris.
Rinse filter with water only, and let air-dry 24 hours
before reinstalling.
s h a r kc l e a n . c o m
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin. Slide the dust
bin back into the robot.
MAINTENANCE

CLEANING THE BRUSHROLL

CLEAN BRUSHROLL EVERY WEEK.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for
replacement parts.
Push up on the tabs on the brushroll access door,
then lift off the door.
Clean the brushroll periodically and whenever hair
appears.
NOTE: When removing the brushroll cap, make sure to not let the bushing inside the cap fall out. When cleaning
brushroll, be sure to not cut anything other than hair, string, fibers, or other debris.
Lift out the brushroll. Remove the cap on the end
of the brushroll. Clean off any hair or debris, then
replace cap.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
s h a r kc l e a n . c o m