Cleaning The Filter; Cleaning The Multi-Surface Brushroll - shark ION ROBOT 700 Série Guide D'utilisation

MAINTENANCE

CLEANING THE FILTER

CLEAN FILTER EVERY WEEK.
REPLACE FILTER EVERY TWO MONTHS. See sharkaccessories.com for replacement filters.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove dust and debris.
s h a r kc l e a n . c o m
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin. Slide the dust
bin back into the robot.
MAINTENANCE

CLEANING THE MULTI-SURFACE BRUSHROLL

THE BRUSHROLL NEEDS OCCASIONAL MAINTENANCE.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for
replacement parts.
Push up on the tabs on the brushroll access door,
then lift off the door.
Remove the blue cap on the end of the brushroll.
Do not let the metal cylinder inside the cap fall out.
Clean off any hair or debris, then replace cap. Clean
the brushroll periodically and whenever hair appears.
NOTE: If the metal cylinder falls out of the brushroll cap, reinsert it in the hole on the inside of the cap. When cutting
away debris, be sure not to cut the brushroll or any other parts of the robot.
Lift out the brushroll.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
s h a r kc l e a n . c o m