Cleaning The Wheels; Cleaning Side Brushes - shark ION ROBOT 700 Série Guide D'utilisation

MAINTENANCE
CLEANING SENSORS AND CHARGING PADS
CLEAN SENSORS AND CHARGING PADS PERIODICALLY AS NEEDED. With a dry cloth or cleaning brush, gently dust off
the sensors and pads located on the bottom of the robot.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.

CLEANING SIDE BRUSHES

CLEAN SIDE BRUSHES AS NEEDED. CHECK WEEKLY.
RECOMMENDED REPLACEMENT SCHEDULE: Replace when visibly worn. See sharkaccessories.com for replacement parts.
NOTE: Remove any side brushes that are bent or damaged. To remove a brush, lift it off its peg. See Installing the Side
Brushes for instructions on how to attach and remove the brushes.
s h a r kc l e a n . c o m
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth. Be sure to
let them air-dry completely before reinstalling them.
MAINTENANCE

CLEANING THE WHEELS

REMOVE AND CLEAN FRONT WHEEL EVERY WEEK. REPLACE FRONT WHEEL EVERY 12 MONTHS.
See sharkaccessories.com for replacement parts.
Pull the Front Caster Wheel from its housing and
remove any debris buildup.
NOTE: Leverage may be required to remove the wheel.
Clean the drive wheel housing periodically as
needed by rotating the wheel while dusting.
Clean the wheel housing, then reinsert the
caster wheel.
s h a r kc l e a n . c o m