Makita HML01 Manuel D'instruction page 8

1
2
012389
NOTE:
The upper handle has two holes each on both
•
sides. Using the different position holes for the
screws and clamping nuts allows the handle height
adjustment.
Removing or installing the blade
WARNING:
Always remove the lock key and battery cartridge
•
when removing or installing the blade. Failure to
remove the lock key and battery cartridge may
cause a serious injury.
The blade coasts for a few seconds after releasing
•
the switch. Make sure that the blade has come to a
complete stop.
Always wear gloves when handling the blade.
•
2
1
1. Screwdriver
2. Blade
3. Bolt
012304
1. Put the mower on its side so that the mowing
height adjusting lever is placed on the upper side.
2. To lock the blade, insert a screwdriver available or
the similars in market into a hole in the mower.
3. Loosen the bolt counterclockwise with the wrench.
1. Screw
2. Clamping nut
3
3. Upper handle
4. Lower handle
4
3
5
1. Inner flange
2. Arrow
3. Outer flange
4. Bolt
5. Blade
012601
4. Remove the bolt, outer flange, blade and inner
flange in order.
To install the blade, take the blade removal procedure in
reverse.
WARNING:
Install the inner flange, the blade and the outer
•
flange carefully as these have a top/bottom facing.
Tighten the bolt clockwise firmly to secure the
•
blade.
Put the blade so that the blade side with a
•
rotational direction arrow faces outward.
Make sure that the blade is installed securely.
•
Always take away the screwdriver or similars
•
inserted in a hole to lock the blade.
8
1
2
3
4