Installing The Handle - Makita HML01 Manuel D'instruction

ASSEMBLY
WARNING:
Always be sure that the lock key and battery
•
cartridge are removed before carrying out any
work on the mower. Failure to remove the lock
key and the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.

Installing the handle

WARNING:
When installing handles, position the wires so that
•
they are not caught by anything in between the
handles.
1. Loosen the clamping screws (two pcs).
3
1. Lower handle
2. Groove on the deck
3. Clamping screw
012385
Expand the lower handle to its both sides and with it
expanded in that position pivot it backward and then fit it
in the groove in the deck.
2. Tighten the clamping screws on both sides to
secure the lower handle.
012386
4
012606
3. Raise the upper handle and align the screw holes
in the upper handle with those in the lower handle
and then secure it with the supplied screws and
1
clamping nuts.
NOTE:
At this time, keep a firm grip on the upper handle
•
so that it does not drop off your hand.
2
2
012421
012605
NOTE:
Install the upper handle so that the direction of the
•
upper handle and the power supply cord are
positioned as shown in the figure.
7
1
3
4
2
1
2
3
5
1
1
2
1. Upper handle
2. Lower handle
3. Screw holes
4. Screw holes
1. Clamping nut
2. Lower handle
3. Upper handle
4. Screw holes
5. Screw
1. Holders
2. Cord
1. Holders
2. Cord