Husqvarna 320iHD60 Manuel D'utilisation page 9

3. Press 1 of the power triggers on the rear handle up
to apply full power.
4. Release the power trigger on the rear handle to
check the free back movement of the power trigger.
The blade must stop immediately.
5. Do step 3 and 4 for each of the other power triggers.
6. Stop the product.
7. Do step 1 and 2.
8. Release the power trigger lockout on the front
handle. Make sure that the power trigger lockout
returns to its original position. The blade must stop
immediately.
To do a check of the hand guard
The hand guard prevents hands from accidental contact
with the blades.
1. Stop the product.
2. Remove the battery.
3. Check that the hand guard is attached correctly.
4. Examine the hand guard for damages.
To do a check of the blades
1. Stop the product.
2. Remove the battery.
3. Put on gloves.
4. Make sure that the blades are not damaged or bent.
Replace the blades if they are damaged or bent.
Battery safety
WARNING:
instructions that follow before you use the
product.
• Only use an approved Husqvarna rechargeable
Approved batteries for the product
battery. Refer to
on page 16 . The battery is software encrypted.
• Use the Husqvarna battery that is rechargeable as
a power supply for the related Husqvarna products
1777 - 006 - 09.06.2022
Read the warning
only. To prevent injury, do not use the battery as a
power supply for other devices.
• Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
• Do not use non-rechargeable batteries.
• Do not put objects into the air slots of the battery.
• Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
• Keep the battery away from microwaves and high
pressure.
• Do not try to disassemble or break the battery.
• If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
• Use the battery in temperatures between -10 °C (14
°F) and 40 °C (104 °F).
• Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 14 .
• Do not use a defective or damaged battery.
• Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
• Keep the battery away from children.
Battery charger safety
WARNING:
instructions that follow before you use the
product.
• Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
• Use an approved grounded mains socket that is not
damaged.
• Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
• Do not try to disassemble the battery charger.
• Do not use a defective or damaged battery charger.
• Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
• Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or similar.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
• Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
Read the warning
9