Ardisam Eskimo F1 ROCKET Manuel De L'opérateur page 11

ORDERING REPAIR PARTS
Parts may be obtained from the store where your auger was
purchased or direct from the factory. To order from the factory,
call, e-mail, or order online at www.geteskimo.com:
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: info@geteskimo.com
Please include the part numbers, part description, quantity,
model number and serial number.
TROUBLESHOOTING:
PROBLEM
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Auger turns at idle
Auger turns, but has no power
Auger jumps on ice
Auger cuts slowly
Contact service provider if above remedies fail, or visit our website at www.geteskimo.com for additional frequently asked
questions.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
Eskimo®
POSSIBLE CAUSE
1. Power switch off
2. Spark plug wire disconnected
3. Out of fuel
4. Spark plug wet, faulty or
improperly gapped
1. Dirty air filter
2. Choke partially engaged
3. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
4. Faulty ignition coil
1. Clogged fuel filter
2. Clogged air filter
3. Faulty ignition coil
1. Idle speed too high
2. Broken clutch spring
1. Choke on
2. Carburetor out of adjustment
3. Broken transmission
4. Worn clutch shoes
1. Blades damaged or sharpened
incorrectly
1. Dull blades
2. Damaged point
ESKIMO
REMEDY/ACTION
1. Flip switch to ON position
2. Connect spark plug wire to spark plug
3. Refuel
4. Clean, replace or gap spark plug
1. Clean or replace air filter
2. Turn off choke
3. Take to authorized service center.
1. Drain old fuel and replace with fresh. Always
use gas stabilizer
2. Make sure spark wire is securely attached to
spark plug
3. Clean carburetor, use gas stabilizer, new gas can
4. Take to authorized service center.
1. Replace filter
2. Remove and clean or replace filter
3. Take to authorized service center.
1. Adjust idle speed lower
2. Replace spring
1. Turn off choke after engine is running
2. Take to authorized service center.
3. Take to authorized service center.
4. Replace clutch shoes and spring
1. Replace blades
1. Replace blades
2. Replace point
Operator's Manual
Power Ice Auger
®
11