Philips S9000 Serie Mode D'emploi page 35

Problem
The appliance
does not shave as
well as it used to.
Water is leaking
from the bottom
of the appliance.
Philips Quick Clean Pod
Problem
My shaver isn't clean
after using the Philips
Quick Clean Pod.
My Philips Quick Clean
Pod does not switch
on.
Possible cause
The shaving heads
are damaged or
worn.
Hairs or dirt
obstruct the
shaving heads.
During cleaning,
water may collect
between the inner
body and the
outer shell of the
appliance.
Possible cause
You removed the
shaver before the
cleaning program was
finished.
The Philips Quick
Clean Pod Cartridge
needs to be replaced.
The Philips Quick
Clean Pod is tilted.
The Philips Quick
Clean Pod is powered
by the motor of the
shaver.
Solution
Replace the shaving heads.
Clean the shaving heads
thoroughly.
This is normal and not
dangerous because all
electronics are enclosed in a
sealed power unit inside the
appliance.
Solution
Leave the shaver in the
Philips Quick Clean
Pod for the full
cleaning program.
Each cleaning program
takes approximately 1
minute. The cleaning
icon goes out when
the cleaning program
is finished.
Replace the Philips
Quick Clean Pod
Cartridge.
Place the Philips Quick
Clean Pod on a flat
surface.
Place the shaver into
the Philips Quick Clean
Pod. Switch on the
shaver.
35
English