Philips S9000 Serie Mode D'emploi page 20

20
English
Note: When the beard styler is attached to the handle,
the motion and pressure feedback is switched off
automatically.
Using the beard styler attachment with comb
You can use the beard styler attachment with the
comb attached to style your beard at one fixed setting
or at different length settings. You can also use it to
pre-trim any long hairs before shaving for a more
comfortable shave.
The hair length settings on the beard styler
attachment correspond to the remaining hair length
after cutting and range from 1 to 5 mm.
Twist the shaving head or other attachment to
1
remove it from the handle and press the beard
styler attachment onto the handle.
2 Slide the comb straight into the guiding grooves on
both sides of the beard styler attachment.
3 Press the length selector and then push it to the
left or right to select the desired hair length setting.
4 Switch on the appliance.
5 Move the appliance upwards while you exert
gentle pressure. Make sure the front of the comb is
in full contact with the skin.
6 Switch off the appliance and clean the attachment
after use.