Baby Jogger CITY MINI 2 Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
IMPORTANT - Read these instructions
carefully before use and keep them for
future reference. Your child' s safety may
be affected if you do not follow these
instructions.
1 Insert wheel axle into the hole on the
underside of the Glider Board. The
wheel is secure when you hear it click.
Repeat on other side.
2 Slide ratchet straps between the lower
cross bar and the brake rods.
3 Push attachment brackets onto lower
cross bar until they clip into place.
4 Slide ratchet strap through opening.
5 Push ratchet strap through until snug.
Repeat on other side.
FULLY EXTEND THE GLIDER BOARD
WHEN IN USE:
6 Pull handle on the rear underside of
Glider Board.
7 Pull out to extend.
NOTE: When glider board is in use, check
canopy height position and seat back recline
position to make sure they are not in the
space where the child is riding.
TO ADJUST GLIDER BOARD ANGLE:
NOTE: Glider board must be parallel to the
ground or slightly angled. Depending on
your stroller model, you may need to adjust
the angle.
8 Push the safety cover away from the
tabs.
9 To Raise: Pull the gray tabs back on
right and left side of Glider Board and
pull edge up.
To Lower: Pull the gray tabs back on
right and left side of Glider Board and
push front edge down.
10 Pull safety cover back over the tabs.
STORAGE
(WHILE USING THE STROLLER):
11 Push in to shorten.
12 Rotate Glider Board Upward and
Forwards.
13 Pull grey handle on underside of Glider
Board then press downwards.
14 Unhook storage straps from underside.
15 Hook storage straps around upper
crossbar of stroller frame.
NOTE: When stored, make sure the rear of
the Glider Board is not interfering with the
back of the stroller seat. Adjust Glider Board
length for storage if necessary.
STORAGE
(WHILE FOLDING THE STROLLER):
16 Follow steps 12,14 and 15 of the Glider
Board Storage instructions (above), then
remove the Glider Board wheels. Press
wheel release button and gently pull
out wheel to remove.
TO REMOVE GLIDER BOARD:
17 Press ratchet lock tab and pull ratchet
strap out. Unclip attachment brackets.
18 Remove Glider Board.
WARNING
• WARNING: Recommended for children
from 2 years old up to a maximum
weight of 45 lbs (20.5kg).
• WARNING: Never leave child unattended.
• WARNING: Always secure seat recline
strap by snapping the D-ring to the
recline clamp before using the Glider
Board.
• WARNING: Always ensure the safety
covers are covering the adjustment tabs
prior to use.
• WARNING: Always make sure storage
straps are fastened to the underside of
the Glider Board before use.
• WARNING: Always make sure the
ratchet straps are securely tightened
before use.
• WARNING: Do not run or skate with this
product attached to a stroller.
5
EN