Worx WX380 Notice Originale page 12

FUNCTION SELECTION
WORKING HINTS FOR YOUR
12
TOOL
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide
drill bits should always be used for concrete and
masonry.
When drilling in metal, only use HSS drill bits in
good condition. Where possible use a pilot hole
before drilling a large diameter hole.
PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a
battery pack for a prolonged time will reduce the
battery pack working time. This can be corrected
after several charge and discharge operations by
charging & working with your tool. Heavy working
conditions such as large screws into hard wood will
use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery
pack below 0 C and above 30
o
performance.
20V Cordless Brushless Rotary
Hammer
For simultaneous
drilling and impacting
of concrete, brick and
stone
For drilling into steel,
wood and plastics
For chiseling into
concrete, brick and
stone
For bit rotation
C as this will affect
o
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance, except for the cleaning & lubrication
of the SDS bits and adaptors before inserting into
the chuck. There are no user serviceable parts in
your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling advice.
EN