Publicité
Les langues disponibles
Les langues disponibles
C-CHANNEL DUAL CAM HP FRAME PLATE INSTALLATION
NOTE: Some C-Channel frames may have square outside corners that do not allow the frame plate to contact the
bottom of the frame. For these type of frames a ½" flat washer (Not Supplied) is required between the outside of the
trailer frame and the frame plate. The bottom of the frame plate MUST contact the bottom of the trailer frame.
1.
With the C-clamps still in place, center punch (2) holes in the frame for
each bracket.
Drill (2) 17/32" holes in each side of the frame where the punched
2.
center marks were made. The use of a center drill or small pilot hole
may be very helpful prior to final drilling.
Install the (2) supplied ½-13 x 1 ½" Bolts, ½" Lock Washers & ½"
3.
Nuts (items 5,6 & 7) figure 12. Repeat for opposite side and torque (4)
½-13 Bolts to 85 ft-lb.
Install ½-13 Hex Nuts onto the ½-13 X 3 ½" Square Head Bolts and
4.
install into the frame brackets as shown in figure 9.
5.
Tighten the Set Screw until it contacts the trailer frame. Then proceed
to tighten ¼ to ½ turn (DO NOT OVERTIGHTEN SET SCREW).
Tighten the Jam Nut preventing the set screw from backing out while in
use. Repeat for other side of trailer frame.
6.
Remove C-Clamps from frame.
© 2014, 2017 HORIZON GLOBAL
Installation Instructions
REESE Dual Cam HP
High-Performance Sway Control
HEX HEAD
BOLT
Sheet 6 of 33
NUT
Figure 9
26002IN
SET SCREW
JAM NUT
LOCK
WASHER
5/31/17
Rev. T
Publicité
