Publicité
Les langues disponibles
Les langues disponibles
TOOLS NEEDED:
Drill Bits: 7/16", 9/16" & ¼"
Failure to follow all of these instructions may result in death or serious injury!
©
2014 , 2017 HORIZON GLOBAL
Installation Instructions
Snap Up Bracket
Read all instructions before installing the additional bolt.
•Installation of an additional bolt into the snap up bracket when using
a Jayco RV with a coupler mounted to the bottom of the frame.
•If a hole does not already exist, mark the location of the hole to be
drilled into the snap up bracket. Center the hole from left to right and
2-1/4"
place it 2-1/4" above the arc in the bracket. See the picture at left.
•Before the bracket is placed on the frame, drill a 9/16" hole in the
bracket
•Place the bracket in the correct place on the frame as directed in the
product instructions or replace it where it was if it had already been
installed.
•Using the hole in the bracket as a guide, drill a ¼" pilot hole. Be sure
to stay centered in the bracket hole.
• One method to stay centered is to use the 9/16" drill first. Just put a
small dimple into the frame with the 9/16" bit. Then finish drilling
with the ¼" drill bit and then a 7/16" drill bit to get the final hole. See
pilot hole to the left.
•Install the ½" self tapping screw into the hole in the bracket and
frame. Tighten it to 50 ft/lbs.
•Re-tighten the ½" set screw on the inside of the frame. Turn only
¼ to ½ of a turn after making contact with the frame.
For Installation or Operation Support contact CPP Technical Service: 1-888-521-0510.
Cequent Performance Products, Inc.
47912 Halyard Dr. Suite 100
WARNING:
PARTS LIST
QTY
DESCRIPTION
2
1/2" x 1.00" SELF TAPPING SCREW
1
INSTRUCTION SHEET
Plymouth, MI 48170
Sheet 10 of 33
26002IN
5/31/17
Rev. T
Publicité
