Reer BeeConnect Mode D'emploi page 25

Problem Possible cause
Signal noise/ • The baby/parent unit is close to interfering
devices (e.g. microwave) or metal objects.
Connection inter-
rupted
• The maximum range has been exceeded.
• Batteries in the baby/parent unit are too
depleted.
LED 2 - 4 light up red • The parent unit receives sounds. Depending
on the noise level, one or several LED light up.
LED 5 lights up green • ECO mode is activated
Baby unit reacts upon • The microphone sensitivity is set too high.
noises that are too
quiet
Baby unit only reacts • The microphone sensitivity is set too low.
upon noises that are
loud
Parent unit does not • Baby monitor is in ECO mode.
emit a signal tone
when the maximum
range is exceeded
Troubleshooting
Action
• Try to find the source of interference and move the
units to a different position.
• Reduce the distance between the baby unit and the
parent unit.
• Replace/charge the batteries and/or connect the
unit to the power supply.
• If necessary, turn up the volume to make sure that
you hear the sounds from your baby.
• No action required.
• Switch the microphone sensitivity to "LOW".
• Switch the microphone sensitivity to "HI".
• In order to activate the range control, push the
switch on the baby unit to "range alarm".
GB
25