Range Control / Eco Mode; Microphone Sensitivity - Reer BeeConnect Mode D'emploi

Range control
This baby monitor is equipped with an optical and acoustic range control system. Baby and parent unit regularly check
mutual contact (even in standby-mode when the baby unit is not receiving any noise). If the range is exceeded, the
status LED on the parent unit will begin to flash red and green and a signal tone will sound at regular intervals.
Note:
To activate range control, ECO mode must be switched off on baby unit.
VOX and ECO modes
CAUTION! If you operate the baby monitor in ECO mode, it may happen that no connection to the baby unit is
established when the parent unit is switched on. This can happen if the baby unit is in sleep mode (no signal trans-
mission = no radiation). In order to force a signal transmission, briefly switch the baby unit to "range alarm" or speak
into the baby unit so the connection can be established.
If you operate your baby unit with batteries, no alarm signal will sound on the parent unit when the ECO mode is
activated and the batteries are flat. Please note: when the batteries are flat, the two device units are automatically
disconnected.

Microphone sensitivity

22
The baby monitor is equipped with an intelligent noise activation (VOX). If no
noises are detected in the room, the transmitter switches to minimum energy
consumption and radiation emission. As soon as the baby unit detects noises, it
activates the radio connection and transfers the data to the mobile parent unit.
As soon as you place the parent unit at a fixed site at which you have checked
reception on a previous occasion, we recommend that you switch ECO mode
on (LED 5 lights up green). In ECO mode, range control is switched off and th-
erefore in standby mode (whenever your child is quiet) the baby unit does not
emit any radiation.
The baby monitor has two selectable levels of sensitivity for the microphone.
Switch the microphone sensitivity on the baby unit to "HI" if you would like to
be notified even at the slightest sound, or the baby unit is too far away from the
cot. If the microphone sensitivity is set to "LOW" status, you will only be notified
upon somewhat louder noises or if the baby unit is close to the cot.