Battery Operation - Reer BeeConnect Mode D'emploi

The status LEDs reflect the condition of the parent unit.
LED status
LED 1
LED 2 - 4
control lamps
LED 5 ECO-LED
OPEN
We recommend also inserting rechargeable batteries to ensure that the units remain operational in case of a power
failure. These will be automatically charged when the parent unit is connected to a power supply. The batteries take
approximately 10 hours to charge (with the device switched off ).
Attention: Only use rechargeable NiMH batteries in the parent unit. Never use non-rechargeable batteries in the
parent unit. Using unsuitable battery types poses an explosion hazard. Switch the units off and disconnect
the power lead before changing the batteries. Check the correct polarity (+/–) of the batteries (as shown
in battery compartment).
Remove the batteries from the device if you do not plan to use it for a long period of time.
LED display
green
green flashing
orange
orange flashing
flashing red and signal tone
alternating red and green with
signal tone
off
red
red flashing
flashing red and signal tone
green
Setting
parent unit is switched on/connection is available
parent unit is switched on/connection is available/bat-
teries are being charged
parent unit is switched off/batteries are charged
parent unit is switched off/batteries are being charged
batteries are weak
no connection to the baby unit/
outside the maximum range
parent unit is switched off
sound is received
connection is being established/connection
interrupted
pager (search function) is activated
ECO mode is switched on (range control is switched
off)
Before first use

Battery operation

CLOSE
GB
21