Publicité
Les langues disponibles
Les langues disponibles
9.2.1 Alarm:
Select here whether the alarm should be activated. The following selection is available: Off / On
Select "Off" to deactivate an activated alarm clock.
9.2.2 Frequency:
Select here on which days the alarm should be activated. The following selection is available: Daily /
Once / Weekends / Weekdays
9.2.3 Wake Up Time:
Set the hours first with the<UP> or <DOWN>buttons and then the minutes after pressing the <OK>.
9.2.4 Source:
Here you set the audio source with which you want to wake up. The following selection is available:
Buzzer / Digital Radio / FM
9.2.5 Preset:
The station with which to wake up is specified here. The station last listened to or the stations saved
in the favourites are available here. Does not apply to buzzer mode.
9.2.6 Duration:
Set the desired alarm duration here. The following options are available: 15 / 30 / 45 / 60 / 90 / 120
minutes.
9.2.7 Volume:
Please set the desired alarm volume here.
Note: An activated alarm clock is shown with an alarm symbol and the number of the active alarm
clock at the bottom of the display. In standby mode you can also see the set alarm time.
9.2.8 Switching off the alarm clock after waking up
To switch off the alarm clock until the next alarm cycle, please press the <Standby> button on the
device or on the remote control "Alarm off" appears briefly on the display. If you only want to inter-
rupt the alarm function for a few minutes (snooze), you can use any other button. The alarm delay is
set by pressing a button in steps 5, 10, 15 and 30 minutes and can also be extended again and again.
After a short time, the radio automatically switches back to "Standby" and the time remaining until
waking up again is displayed next to the flashing alarm symbol.
Note: The saved wake-up times are retained in the event of a power failure.
14
Publicité
