Kenwood CR-ST80DAB Mode D'emploi page 32

5.5.1 Storing DAB+ stations on the direct selection buttons 1-5 on the radio:
On the radio, you can assign memory locations 1 - 5 using the number keys. To do this, select the
desired station and press a number key until "Preset x saved" appears in the display. The memory
locations can be called up by pressing the button briefly.
5.5.2 Storing DAB+ stations with the remote control:
Memory locations 1–10 can be assigned using the number buttons on the remote control. To do
this, select the desired station and press a number key on the remote control until "Preset x saved"
appears in the display. The memory locations can now be called up by pressing the remote control
briefly.
5.5.3 Saving DAB+ stations in memory locations 11 - 40:
Select the desired station and hold down the <FAVORITE> button on the radio or <FAV> on the
remote control. Now select a memory location from the list of station memories and confirm the
selection with the <NAVIGATE> button on the radio. "Preset x saved" appears on the display. You
can easily call up the memory locations by briefly pressing the <FAVORITE> button on the radio or
<FAV> on the remote control. Use the <UP/DOWN> buttons or the <NAVIGATE> knob to select a
station and press <OK> to confirm.
Note: The memory locations cannot be deleted, but can only be overwritten with other stations.
Stored stations are marked in the lower part of the display by an asterisk with the corresponding
memory location number.
5.6 DRC (Dynamic Range Control):
Some DAB+ stations support DRC, which reduces the difference between loud and soft tones. The
following settings are possible:
High:
Strong compression of the different volumes. The dynamic is greatly reduced.
Low:
Low compression without much loss of dynamics
Off:
There is no compression
To make the settings, proceed as follows:
Press the <MENU> button and select "DRC". The settings for DRC can be changed in the following
menu. The current setting is indicated by "ü".
5.7 Station order
By default, the radio sorts the stations in alphanumeric order. The stations can also be sorted accord-
ing to ensembles or valid (currently receivable) stations.
To make the settings, proceed as follows:
Press the <MENU> button and "Station order". The settings can be changed in the following menu.
The current setting is indicated by "ü".
10