Tru-Test S150 Manuel De L'utilisateur page 11

Battery symbol flashing
(0.25 J model only).
Battery symbol flashing
and display shows
(0.25 J model only).
Display shows
(0.25 J model only).
Servicing
This energizer contains no user serviceable parts. It must be returned to a service agent appointed by Tru-Test Group for
repair.
Product specifications
Power source
Typical current consumption
Maximum output
Voltage
Energy
Typical output at 500 Ω
Voltage
Energy
Stored energy
Values are typical and normal production tolerances of ±10% should be allowed for.
The battery is running very low. The energizer may be operating normally, see
Power-save
on page 5. However, you should check the following:
Check the energizer installation. See
The energizer may not be installed correctly. Make sure the energizer is positioned
to receive maximum sunlight. See
The solar panel may be dirty. Clean the solar panel. See
page 7.
There may not be sufficient sunlight to recharge the battery. If the battery symbol
continues to flash, recharge the battery manually. See
The battery is not connected or is faulty. Ensure the battery is connected properly.
Installing the battery
See
An incorrect security code has been entered five times. The energizer is now
locked and will not operate. Take the energizer, with proof of purchase, to your
nearest Tru-Test Group distributor for unlocking.
0.15 J model
12 V, 7 Ah, sealed lead-acid battery (all models)
<20 mA
up to 10 kV
up to 0.15 J at 2000 Ω
up to 2.6 kV
up to 0.13 J
0.2 J
Installation
Positioning the energizer
on page 3. Replace the battery if required.
0.25 J model
10-25 mA
up to 8.5 kV
up to 0.23 J at 800 Ω
up to 3.1 kV
up to 0.22 J
0.3 J
on page 3.
on page 3.
Energizer maintenance
Battery charging
0.5 J model
15-50 mA
up to 9.6 kV
up to 0.52 J at 600 Ω
up to 4.8 kV
up to 0.51 J
0.64 J
on
on page 7.
11