Haussmann Xpert 58485005 Manuel De L'utilisateur page 21

SQUARING SAW TABLE TO THE BLADE
Refer to Figure 2 and 3
• Loosen the drop foot lock knob and move drop foot rod
all the way up. Retighten drop foot lock knob.
• Loosen the arm lock knob to tilt the saw arm until it is
approximately perpendicular or at a right angle to the
blade.
• Place a small combination square on the saw table next
to the blade to check squareness.
• Loosen the screw holding the scale indicator. Move
indicator to the 0° mark and securely tighten screw.
(See Figure 3.)
• Remember, the bevel scale is a convenient guide but
should not be relied upon for precision. Make practice
cuts on scrap material to determine if your angle
settings are correct.
• Adjust the drop foot to desired position and securely
retighten the drop foot lock knob.
Figure 2
Arm Lock Knob
Figure 3
Angle Indicator
Drop Foot Rod
Drop Foot
Lock Knob
Bevel Scale
20
SETTING SAW ARM FOR HORIZONTAL OR
BEVEL CUTTING
Refer to Figure 4
A bevel scale is located under the saw table as a conve-
nient guide for setting the approximate saw arm angle for
bevel cutting. When greater precision is required, make
practice cuts on scrap material and adjust the saw table
as necessary for your requirements.
NOTE: When cutting at angles, the drop foot should be
tilted so it is parallel to the saw table and rests flat against
the workpiece. To tilt the drop foot, loosen the drop foot
know, tilt drop foot to the proper angle, and then retighten
screw.
• Loosen the Saw Arm lock knob and pull down to the
right of the arm, if the arm stops at 0°, the zero degree
stop is properly set. If the table stops somewhere other
than zero, adjust the zero degree stop.
Figure 4
Drop Foot Knob
Drop Foot
Angle Indicator
Bevel Scale