Troubleshooting - Exquisit BP 6102 sw Instructions D'emploi

18 Troubleshooting

Defects
The vacuum
cleaner doesn't
work
If the vacuum
cleaner does not
have any suction
power
If the vacuum
cleaner doesn't
work as it ought to
or if there are
noises and/or
whistling sounds
If the cord does
not rewind
completely
In case of doubt consult a qualified expert.
Seite | 34
Possible reason
The appliance is not switched on
The electrical plug is defective
The appliance is not plugged into
the receptacle
An accessory part: The hose or
pipe or nozzles or brushes are
blocked
The HEPA filter is soaked/dirty
An accessory part: The hose or
pipe or nozzles or brushes are
blocked
The dust container is full
The cover of the container is not
correctly positioned
The dust collector is not correctly
positioned
The manual air flow controller is
open
Solution
Switch the
appliance on.
Contact a qualified
technician.
Plug the appliance
into the
receptacle.
Remove whatever
is causing the
blockage.
Clean the filter.
Remove whatever
is causing the
blockage.
Empty it and clean
it.
Close the cover
well.
Position it
correctly.
Close it.
Rewinding the cord
is slow: unwind it
and press the
button again.