Operating Instructions - Exquisit BP 6102 sw Instructions D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Do not bring the power cable
into contact with hot parts.
Do not expose the vacuum
cleaner to high temperatures
(heating etc.) or weather
conditions (rain etc.)
• Do not use the floor vacuum
cleaner any longer if its plastic
components have tears or
cracks or have been
deformed.
• Do not use the appliance
without HEPA filters.
• Do not suck up burning or
glowing items such as
cigarettes or seemingly
extinguished ash.
• Do not suck up liquids or
damp dirt. Let damp cleaned
or shampooed carpets dry
before vacuuming.
• Do not suck up toner dust
from printers or copiers. The
filter system cannot filter
toner dust perfectly. The toner
dust would be blown into the
room again by the blower.
• Do not vacuum up easily
flammable or explosive
materials or gases.
• Do not vacuum up sharp
edged, heavy or hard objects.
The vacuum cleaner would be
blocked.
• Do not stand or sit on the
vacuum cleaner.
Assembling the vacuum
cleaner
PLEASE NOTE!
Depending on what you would
like to vacuum, there are four
attachments, from which to
choose. For a dusty carpet or a
hard floor use the floor nozzle.
With the foot pedal you can
lower or expose the integrated
bristle ring (D)
• We recommend the crevice
nozzle for corners that are
hard to reach (see
accessory).
• For sensitive or shaped
articles use the brush nozzle
by putting it on the crevice
nozzle.
• For pieces of furniture there
is an upholstery nozzle.

15 Operating instructions:

Please note:
Only use the appliance if all parts
are fully and correctly installed.
In case of doubt have it
examined and assembled by a
qualified specialist.
Every time before you use it,
make sure that the appliance is
in good condition and that the
power cord isn't damaged: if the
cord is damaged, it must be
replaced by the manufacturer or
the service center or by someone
with a similar qualification, in
order to prevent any risks.
• Place the vacuum cleaner
housing on the floor.
• Stick the suction piece of the
flexible hose into the suction
opening of the vacuum cleaner
(B)housing. The hose must
snap into place perceptibly.
• Put the handle of the hose on
the telescopic pipe (C). The
hose must snap into place
perceptibly.
• Put the desired suction nozzle
to the other end of the
telescopic pipe.
• Use the floor nozzle (D)to
clean dusty carpets or hard
floors.
Seite | 29

Publicité

Table des Matières
loading

Table des Matières