Connecting The Ethernet To The Stub - Sagem Monetel EFT930S Livret D'installation

7.2 CONNECTING THE ETHERNET TO THE STUB

Note: the terminal and the Ethernet cable are clearly color coded (yellow).
Safety instructions reminder:
Select a power supply socket in compliance with the general safety instructions given in section 1 of this document.
A
A
B
B
D
D
E
E
A = Ethernet socket
C = Ethernet link
E = power adapter
G = serial port input (cash register, local loading
tool)
Carry out the following operations:
• Connect the stub to the Ethernet:
- Connect plug B to the Ethernet A .
- Connect the other end of the cord to socket C on the stub.
• Connect the power adapter E to the incoming power supply socket.
• Use the link provided to attach the power supply input cable and prevent unwanted disconnections (see
section "attaching the stub").
Plugs B and C: These links establish SELV circuits (Safe Extra Low Voltage according to standard EN 60950) and
must be interconnected with equipment whose ports are powered by similar circuits.
Socket G: This link establishes SELV circuits (Safe Extra Low Voltage) and must be interconnected with equipment
whose ports are powered by similar circuits.
These connections are to be made with the device switched off.
C
C
F
F
B
D
F
34/44
F
G
= Ethernet connection
= power supply socket
= power input
C
3000139813-03/721