Publicité
10 DIAGNOSTICS
Photocell Test:
The control unit is prearranged for connection of safety devices in
compliance with standard EN 12453 point 5.1.1.6. At each operating
cycle a functional test of the connected photocell is performed. In the case
of an open circuit and/or malfunctioning of the photocell, the control unit
does not enable movement of the gate and visually signals the test failed
condition by causing all the indicator LEDs to blink simultaneously. As soon
as correct operation of the photocell is restored, the control unit is ready
for normal use. This operating mode guarantees failure mode monitoring in
compliance with EN 954-1 Category 2.
Commands input test:
In correspondence with each low voltage command input, the control unit
is equipped with an indicator LED so that the status of the input can be
checked at a glance.
Operating logic: LED on input closed, LED off input open.
11 WARRANTY
11.1 - In business relationships or in case of products sold for professional
use, this warranty is limited to the repair or replacement of product parts
that FRATELLI COMUNELLO SPA acknowledges as defective, through
equivalent re-manufactured Products (the "Conventional Warranty"); the
warranty does not include the costs necessary for repairing or replacing the
material (e.g. labour costs, rental of equipment etc).
11.2 - The provisions contained in articles 1490 to 1495 of the Italian Civil
Code shall not apply.
11.3 - FRATELLI COMUNELLO SPA warrants the proper operation of the
products within the limits indicated in a) above. Unless otherwise agreed,
the validity of the Conventional Warranty is 24 (twenty-four) months from the
production date, which can be found on the products. The Warranty shall
be effective and binding on COMUNELLO only if the product has been
correctly installed and maintained in accordance with the installation and
safety rules set out in the documentation provided by COMUNELLO or
otherwise available on the website http://www.comunello.com/corporate/
general_conditions_sales/
11.4 - The warranty does not cover: failures or damage caused by transport;
failures or damage caused by defects in the electrical system of the buyer
and/or by carelessness, negligence, inadequate or abnormal use of such
system; failure or damage due to tampering carried out by unauthorized
personnel or due to incorrect use / installation (in this regard, system
maintenance at least every six months is recommended) or the use of non-
original spare parts; defects caused by chemical agents and/or atmospheric
phenomena. The warranty does not cover the cost of consumables; in
any event, COMUNELLO shall be entitled to a consideration for the work
performed at the Customer, where such work proves useless as the
warranty did not apply or because the customer had used the Comunello
product in a negligent, reckless or incompetent manner, such that the
proper use of the product could have avoided the work.
11.5 - Implementation terms: unless otherwise agreed, the right to the
Conventional Warranty is exercised by showing a copy of the purchase
document (invoice) to COMUNELLO. Any defect must be notified to
COMUNELLO within the time limit of thirty (30) days from detection of the defect.
The action must be exercised within the limitation period of 6 (six) months from
detection of the defect. The Product parts for which the Customer requests
application of the Conventional Warranty must be returned by the Customer
to FRATELLI COMUNELLO SPA, Via Cassola 64, 36027 Rosà (VI) Italy.
11.6 - The Customer cannot claim compensation for indirect damage, loss
of profits, loss of production and in any case it cannot claim compensation
for an amount that exceeds the value of the supplied components or
products. All transport costs for Products that have been repaired or to be
repaired, although covered by the Conventional Warranty, shall be charged
to the Customer.
11.7 - No external work carried out by Comunello technical staff is covered
by the Conventional Warranty.
11.8 - Specific amendments to the Conventional Warranty conditions
described herein can be defined by the parties in their commercial contracts.
11.9 - The Court of Vicenza (Italy) shall be the place of jurisdiction for any
dispute which will be settled according to the Italian laws.
COMUNELLO ®Copyright 2021 - All rights reserved
35
Publicité
