Cleaning, Care And Maintenance; Service; Disposal - AEG 10648 Mode D'emploi

CLEANING,
CARE AND
MAINTENANCE
always maintain clean leads and check
jumper leads for damage prior to each
use. Do not use damaged jumper leads
(e.g. frayed lead, broken or welded
terminal clamps). Please contact your
retailer or a qualified professional for
damages, repairs or other product
issues.
Replacing the batteries of the LED
light
3 3
1. unscrew the screws (1) from the
cover (2) using a suitable cross-tip
screw driver.
2. Remove the cover (2).
3. Replace the batteries (3). Note the
correct polarity when inserting the
batteries.
1 1
0 0 I I
2 2
4. Reattach the cover (2).
5. If necessary, replace the batteries
inside the other clamp. The clamps
are now ready to use again.

Service

Should you have any questions regard-
ing commissioning or operating in spite
of studying these operating instruc-
tions, or if a problem should occur
against all expectations, please get in
contact with your specialist supplier.

Disposal

The packaging consists of non-contam-
inating materials that you can dispose
of at your local recycling point.
Do not throw electrical appliances
in with domestic waste!
In accordance with European Directive
2012/19/EC for waste electrical and
electronic equipment (WEEE) and con-
version to national law, used electrical
appliances must be collected separately
and taken to a recycling point. For ways
to dispose of old electrical appliances
please contact your community or city
administration.
Illustrations may vary slightly from the
product itself. We reserve the right to
modify the product in accordance with
technical advances. Decoration not
included.
English 21