Disconnecting; Using The Led Light - AEG 10648 Mode D'emploi

www.aeg-automotive.com
20

Disconnecting

Note:
before disconnecting the jumper leads
the rear and front defrost should be
switched on in the vehicle with the
drained battery (do not switch on
vehicle lights). This will reduce possible
voltage spikes whilst disconnecting and
prevent damaging electrical parts.
Disconnect the terminal clamps in the
following order:
Caution!
When disconnecting the jumper cables,
be careful they do not come into
contact with the moving parts of the
engine.
2
3
1. Negative lead (black) from earth
point of vehicle with drained battery.
2. Negative lead (black) from negative
terminal of good battery.
3. Positive leads (red) in any order
After jumpstarting drive the broken-
down vehicle for a longer distance
to charge the battery. You may also
recharge the battery with a charger.
3
1

Using the LED light

Set the switch (4) to the "I" position to
switch on the LED light on the clamps.
Set the switch (4) to the "0" position to
switch off the LED light.