Operation - Schwamborn BEF 320EX Traduction Du Manuel D'utilisation D'origine

EN Floor milling machine BEF 320EX / BEF 320VX

3 Operation

BEF 320VX:
Risk of injury / Risk of damage
due to highly‐inflammable, toxic fuel.
Petrol and motor oil are environmentally haz­
ardous and must not get into ground water!
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking or smoking at the workplace is
prohibited! Always eat in break rooms or can­
teen areas! After completing the work,
thoroughly clean yourself!
A general inspection of the machine must be
conducted before starting up the machine.
Particular attention should be paid to damaged
or loose components, and wear.
The machine may only be put into operation in
perfect technical condition.
Do not operate the machine in areas where
there is risk of explosion or near flammable
materials!
Adding to or modifying the machine in any way
that could compromise operating safety is
prohibited!
3 Operation
Observe the safety instructions in Chapter 2.
Risk of injury from parts flung out during milling!
Wear protective clothing and protective goggles!
Wear safety shoes!
Wear safety gloves!
Proceed with the greatest care and caution!
18
Danger of injury from loud noise during milling
operation of the machine!
Always wear hearing protection when the
machine is in operation!
Risk of injury from parts flung out! The surface
to be milled has to be free from obstacles, soil­
ing and loose objects that can be flung out dur­
ing milling.
Risk of injury from rotating machine parts! Limbs
and clothing can be drawn in!
Proceed with the greatest care and caution!
BEF 320EX:
High‐voltage electrical current can be fatal! Do
not allow the power line to be run over, crushed
or pulled on!
The operating range is limited by the length of
the power line. Stop the machine in time!
Risk of injury from dust formation during milling
work!
The machine must always be operated with a dust
extraction system with a corresponding filter!
Respiratory protection must be used!
Risk of injury due to high temperature on motor,
drive elements and milling rotor! These parts
may still be hot after operation.
BEF 320VX:
Additional risk of injury from hot exhaust parts
[33, Fig. E] and hot exhaust air!