Enter Function Menu; Start Recording; Stop Recording; Show Remaining Time Until Start/End Of Recording - VOLTCRAFT 1435090 DL-200T Mode D'emploi

• The protective cap must be removed for inserting/changing battery or
reading the saved data via a computer. Pull the protective cap off the
device.
• Attach the protective cap tightly to data logger before next recording.
a) Enter function menu
Press button DOWN (6) to enter the function menu. The latest recorded
measurement, logger ID and selected start/stop mode during configuration
appear in sequence by consecutive presses of the button DOWN.
b) Start recording
• Recording starts based on configuration setting "RECORD START
CONDITION".
• When the data logger starts recording, "
• "P" indicates data logger is ready for recording and it disappears once
the data logger records.
c) Stop recording
• Recording stops based on the configuration setting "STOP STYLE".
When the "NONE" stop style was selected, then the recording stops
based on the setting "RECORD START CONDITION".
• When the data logger stops recording, "
d) Show remaining time until start/end of recording
• Press button DOWN (6) to enter the function menu.
• Press button DOWN consecutive until "TIME START" and/or "TIME
STOP" and remaining time (in hours/minutes or days) are shown in
LC-display.
Time duration below 24 hours is in HH:MM format. If the remaining time
exceeds 24 hours, it is shown as days " ".
" appears on the LC display.
" appears on the LC display.
87