Bosch PFS 7000 Notice Originale page 21

Symbols and their meanings
Step 2:
Setting the spray mater-
ial quantity
Set the "wood/glaze"
application at the air
flow control (25)
Step 3:
Setting the air flow
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is intended for spraying all common paints:
Emulsion and latex paints (wall paints), solvent-based and
water-dilutable (recommended) lacquers, glazes, primers,
impregnations, clear lacquers (ALLPaint), oils and water.
The power tool is not suitable for use with caustic solutions,
wood stains, acidic coating materials, disinfectants, pesti-
cides and house paints.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Spray gun
(2) Air cap
(3) Cap nut
(4) Thumbwheel for spraying capacity
(5) Trigger switch
(6) Lock ring
(7) Container for spray material
(8) Spare container for spray material
(9) Hose port (spray gun)
(10) Nozzle cap (white: for "wall" application)
(11) Nozzle cap (grey: for "wood/glaze" application)
(12) Nozzle cap (black: for "wood/lacquer" application)
(13) Filling sieve
a)
(14) Transfer bucket
(15) Nozzle needle
(16) Container seal
(17) Suction tube
Bosch Power Tools
Set the "wood/lacquer"
Set the "wall" applica-
application at the air
tion at the air flow
flow control (25)
control (25)
(18) Ventilation hole
(19) Paint channel
(20) Air hose
(21) Bayonet lock
(22) Base unit
(23) Carrying handle
(24) Holding clamp
(25) On/off button with air flow control
(26) Hose port (base unit)
(27) Accessory compartment
(28) Cleaning brush
(29) Air filter cover
(30) Air filter
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical Data
Fine-spray system
Article number
Rated power input
Spraying capacity
Required time for application
2
of paint on 4 m
Container capacity for spray
material
Length of air hose
Weight according to
EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These spe-
cifications may vary at different voltages and in country-specific mod-
els.
Only for power tools without starting current limitation: Switching
these on causes the voltage to drop briefly. Other tools may be ad-
versely affected by these if the conditions in the electricity supply are
unfavourable. Malfunctions are not to be expected for system imped-
ances below 0.438 ohm.
English | 21
Detailed description
(see "Setting the air
flow (see figure D)",
page 24)
PFS 7000
3 603 B07 4..
W 1400
ml/min 700
min 1
ml 1000
m 4
kg 4.8
/ II
1 609 92A 6SH | (10.06.2021)