Oceanic AFGD1750WB Guide D'utilisation page 36

1.2 turns to
The working mode of the fan and the rack cannot be controlled by the remote control or Fan
switch.
2. Fan heater switch:
2.1 When the device is in standby mode, the fan heater switch's green light will be always
on, short press the fan switch device fan to start heating alone (Red light flashing at 1Hz),
the frame is not heated at this time, after 30 min heating the device enters standby mode. If
you short press the Fan heater switch again in the heating state, the fan stops heating and
returns to the standby state.
2.2 In the state of remote control, short press the blower fan switch to start heating fans
alone (Red light flashing at 1Hz), the radiator rack stop heating at the same time, the device
enters standby after 30 minute. If you short press the Fan heater switch again in the heating
state, the fan stops heating and returns to the standby state.
LCD DISPLAY
8. GENERAL INFORMATIONS ：
8.1. Ambient temperature range required for equipment operation: 0 ～ 55℃
8.2. Temperature setting range: 7 ～ 30℃
8.3. Time pattern: 24:00
9. Panel display:
, Power off, the fan and the rack are powered off at the same time,