Oceanic AFGD1750WB Guide D'utilisation page 29

 The device must be powered by a Residual Current Device (RCD) with a rated operating
differential current of not more than 30 mA.
 The device must be connected to a circuit independent electric protected by a bipolar circuit
breaker according to the standard electrical installation NF C 15-100.
 CAUTION: To avoid hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be powered via an external switch, such as a timer, or connected to a
circuit that is regularly switched on and off by the electricity supplier.
 The heater must be installed so that switches and other control devices can not be touched
by a person in the bath or shower.
 A means of disconnection from the power supply having a contact opening distance of all
poles must be included in the fixed wiring in accordance with the installation requirements.
 For your safety, the device is equipped with a thermal circuit breaker. In the event of
overheating, the power supply will be cut off.
 With respect to the details of how to install the appliance onto the wall, refer to the
"INSTALLATION" section.
 Regarding the detailed information on the connection of the electric cable, refer to the
section "ELECTRICAL CONNECTION".
Ref:OCEASHS1750B1\OCEASHS2000W1\OCEASHS2000B1
Radio frequency bands used by the Transceiver 2412MHz to 2472MHz
Maximum radio frequency power: <100mW
The undersigned, OCEANIC, declares that the radio equipment of the electric towel radiator
type Ref: OCEASHS1750B1\OCEASHS2000W1\OCEASHS2000B1; complies with directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.oceanic.eu.
INSTALLATION
RECOMMENDATIONS IMPORTANT READ BEFORE INSTALLATION
-
Do not install the unit directly below a socket.
- Do not use the appliance outdoors.
- Do not install the unit in an air current that could disrupt its regulation.