Bestron AAC12000 Mode D'emploi page 46

1. Explanation remote control:
A. Button on/off "POWER"
B. Timer function button "TIMER"
C. Adjust slat position button "SWING"
Press 1x = continued swing
Press 2x = set new position
D. Set sleep mode button
E. Set temperature/time button
F. Set mode button "MODE"
G. Set ventilator speed button
H. Set temperature unit button:
Celsius or Fahrenheit
CLEANING AND MAINTENANCE - General
Over time, dust can accumulate in the grids and between the fins in the appliance.
1. Switch off the appliance and unplug it.
2. Remove the dust from the grids and louvers with a hand brush and/or vacuum cleaner.
3. Clean the casing with a soft, damp cloth. Then dry it thoroughly with a dry cloth. Never immerse the
appliance in water! Make sure that no moisture gets into the electrical connections.
CLEANING AND MAINTENANCE - Water drainage
The device is equipped with an internal water collector. When it is full, the appliance stops working and the
indicator light on the control panel lights up to "FULL".
1. Switch off the appliance and unplug it.
2. Place the appliance on a raised platform and
place a bucket or other type of container under
the drainage hole of the water collector.
3. Unscrew the rubber cap from the drainage hole
(figure 1-8), see also figure 7. The water flows
from the water collector into the bucket.
4. When the water collector is empty, put the
rubber cap and screw cap back into the drain
hole and make sure it is tightly closed.
ATTENTION:
• Move the appliance carefully and always vertically to prevent water from leaking over the edge of the
internal water collector. When emptying, you can tilt the appliance slightly to get the last water out of the
water collector.
• If the bucket or other type of container cannot collect all the water at once, replace the rubber cap of the
drainage hole in the meantime. Empty the bucket and repeat the steps.
Continuous drainage
If you frequently use the device to dehumidify or cool air, you can also use the continuous discharge.
1. Switch off the appliance and unplug it.
2. Unscrew the screw cap and rubber cap from
the continuous drain hole (figure 1-10), see also
figure 7.
3. Connect a 21 mm (1/2") connector with drain
hose (not included) to the drain hole (19 mm,
see figure 8) and make sure that the end of the
hose ends in a drain, bucket or other type of
receptacle.
4. Use the device as indicated in this manual.
A
B
C
D
46
EN
E
F
G
H
6
7
8