Télécharger Imprimer la page

Innotek ULTRASMART IUT-300C Mode D'emploi page 9

Publicité

Les langues disponibles

Les langues disponibles

Training Tips
• Watch the included DVD to get the basics for training your
dog properly with a remote trainer.
• We recommend your dog be at least six months old before
starting a remote training program.
• Always praise your dog for good behavior!
• Teach him what the commands mean before introducing the
collar as a reinforcement tool.
• Keep training sessions brief, about ten minutes of training
and then a rest or play period of at least equal length.
• Dogs learn through repetition. You may have better training
success if you can elicit an undesired behavior when you can
anticipate it. For example, if the dog misbehaves and jumps
on visitors, have someone come in and out of the front door
several times over a half-hour period. You'll be expecting it
and will be ready to teach your dog the right behavior.
• Always end a training session on a positive note. Let the dog
have success. This way he'll look forward to the next session.
• Training should be fun for both you and your dog. Never train
when you are angry. If you get frustrated during training, stop
and come back to it later. Your dog will learn better when you
are both relaxed.
• The goal of training is to condition your dog to respond to
your verbal commands under all situations. You should plan
on using the collar for at least four months. A good rule is,
once started with a remote trainer, to regularly have the collar
on when you take the dog out. This will ensure that he will
always be imprinted with the correct response to your
commands and that you are always in control.
Troubleshooting
If the collar appears not to be working, try the following:
• Adjust the collar strap to fit.
• Test the collar. If no light, replace the battery.
• If the remote display is out, replace the remote battery.
• Turn on the components as shown in the Quick Start Guide.
• Check that the contacts are tightened
• Ensure that the contacts are touching the dog's skin.
• If necessary, trim the dog's hair or use the longer contacts to
ensure proper skin contact. Never shave the dog's neck.
• Try a stronger stimulation level.
If you cannot solve the problem by following these steps, please
call your authorized Innotek Service Center.
IMPORTANT ADVICE
1. Read the complete instructions and follow all directions. If you
have any questions, please call your authorized Innotek
Service Center.
2. This device is intended for use only on dogs. Never attempt to
use it for any purpose not described in this manual.
3. Keep out of the reach of children.
4. Never perform set-up procedures while the collar is on your
dog.
5. Any collar worn for extended periods can cause a condition
similar to bedsores, known as Pressure Necrosis. To reduce
the possibility, you must do the following:
• Never leave the collar on the dog for more than 12
consecutive hours.
• Examine the dog's neck daily for any signs of a rash or a
sore.
• Supervise your dog during the first 2 days of training.
• Check the fit to prevent excessive pressure; you should be
able to insert one finger between the collar strap and your
dog's skin.
• Wash the dog's neck area and the contacts of the collar
weekly with a washcloth and mild hand soap; rinse
thoroughly.
• If the condition persists beyond 24 hours, see your
veterinarian.
8

Publicité

loading

Ce manuel est également adapté pour:

Ultrasmart iut-300e