Publicité
Les langues disponibles
Les langues disponibles
INNOTEK
®
UltraSmart
Micro Remote Trainer
Model IUT-300C
Understanding the Remote
The handheld remote signals the electronic
collar to produce a harmless yet effective stimulation or tone.
Remote Buttons:
STIMULATION (red central button)– sends stimulation signal to the
collar at the intensity shown in the display window. Button features
four raised bumps, one at each corner, to easily locate by touch.
Level UP (+) & Level DOWN (-) – adjusts the
stimulation intensity through a range of levels. From
Low-1 to High-9.
TONE
– Produces a training tone from the collar. No
stimulation is delivered. See page 4, "Tone Option". Button is also
used to turn collar ON/OFF.
Dog 1/Dog 2
– Switches remote controls from Collar 1 to Collar
2, great when training two dogs. IUT-300C users can purchase a
second accessory collar to expand their system to train two dogs.
BOOST
– Produces stimulation 2 levels higher than the
currently selected level. For example, if the stimulation level is set
at Level 2, a touch of the
trainers like instant access to a higher setting for circumstances
where the dog may not respond to lower levels, such as around
high distractions.
Antenna
The antenna helps transmit the signal to the collar. Take care not
to cover or shield the antenna with your body or hand or you may
see a reduction in transmission range.
™
control will stimulate at Level 4. Some
Digital Display
The display shows stimulation levels 1 through 9.
The lower part of the display shows which collar is
active. Press
button once or twice until Collar 1
icon
shows as active. Pressing the red stimulation button sends
a correction command to the collar indicated on the display. The
active collar icon will display at the bottom of the window. The
display will stay ON, only going OFF 30 minutes after the last
button press.
Power Up
Remove the battery access door by unscrewing it with the edge of
a small coin. Insert the 12v alkaline battery, ensuring proper +/-
polarity. Replace the door and tighten by screwing down with the
coin.
The remote is waterproof, though submersion is not
recommended. It operates on a replaceable 12v alkaline battery
(23A or A23). These are commonly available where you bought
your system or where batteries are sold.
ON/OFF
To turn the collar ON or OFF, hold the collar within one inch of the
remote antenna, taking care not to touch the metal contacts that
touch your dog's skin. Press the Tone
emit a start-up tone, and the light will glow solid green.
This ON/OFF command only works when remote and collar are in
close proximity; it will not work
at a distance. Never turn the
unit ON/OFF while your dog is
wearing the collar.
About Stimulation
We recommend that you
always start training your dog
4
button. The collar will
Remove battery door with
screwdriver or coin
Publicité
