THOMSON TT350 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Getting started
Safety warning and notice
Getting started
Take the device out of the box
Remove all the packaging from the product.
Place the packaging inside the box and either keep or dispose of properly in compliance
with the waste sorting instructions shown on the product packaging.
Safety warning and notice
You must read and understand all the instructions before using this device. The warranty will
not apply if damage is caused by failure to follow the instructions.
1. Never remove the device casing.
2. Never place this device on other electrical equipment.
3. Protect the power cord from being walked on or pinched, particularly at the
plugs, sockets, and the point where it exits the device. Make sure that the
power voltage corresponds to the voltage shown on the rating plate at the
rear of the device. Always pull the plug from the socket when disconnecting
from the mains. Never pull on the cord. Ensure you have completed all the
other connections before connecting the plug.
4. Only use attachments/accessories that are recommended by the
manufacturer.
5. Entrust all device repairs to qualified repairers. A repair is needed when the
device has been damaged in any fashion, and in particular:
- if the power cord is damaged;
- in the event of a liquid spill or objects being inserted into the device;
- if the device is exposed to rain or humidity;
- if the device does not operate normally;
- or if the device has been dropped or impacted.
6. The series panel is located on the bottom of the device.
7. Never block the air vents.
8. Ensure you have sufficient stable space around the device for ventilation.
9. This device must be used in a moderate climate, away from direct sunlight, naked flames
or heat, heating devices, cookers or any other device (including amplifiers) that generates
heat. Do not install near a heat source.
10. The batteries (battery pack or inserted batteries) must not be exposed to excessive heat,
such as sunshine, fire, etc.
11. Always unplug the device before cleaning it. Never lubricate any part of this device. Clean
11
11
13
13
14
15
- EN 11 -
15
16
17
17
17

Publicité

Table des Matières
loading

Table des Matières