Niko 05-201 Mode D'emploi page 57

05-201
- Operation of the installation is not possible or not all modules are available for the
Nikobus Windows software.
—> Wrong polarity: measure the voltage and polarity between the different modules.
—> Connect correctly B1, B2, B'1 and B'2.
- The communication between the PC-Logic and the PC does not function.
—> Check that all cables have been correctly connected.
—> Check that the serial interface is not being used by other software.
9. LEGaL WaRNINGS
- The installation has to be carried out by a qualified person and in compliance with the
statutory regulations.
- This user manual has to be handed over to the user. It has to be included in the electri-
cal installation file and has to be passed on to any new owners. Additional copies are
available on the Niko website or via the support service.
- During installation, the following has to be taken into account (not limited to list
below):
- The statutory laws, standards and regulations;
- The state of the art technique at the moment of installation;
- This user manual, which must be read within the scope of each specific installation,
only states general regulations;
- The rules of proper workmanship
- In case of questions, you can consult Niko's support service or contact a registered
control organisation.
GB 57