Niko 05-201 Mode D'emploi page 55

05-201
The function is ALWAYS active during standard operation. This means that this function
is automatically activated AFTER programming the PC-Logic. On the PC-Logic display, the
letter 'M' appears in the upper left corner. If this is not the case, this function must be
switched 'ON' manually, otherwise, the PC-Logic will not function.
1. Briefly press
2. Briefly press
3. Briefly press
screen.
6. CoNfIGuRaTIoN VIa PC
The connection between the serial (COM)
port of the PC and the PC-Link is made
by means of the supplied DB9 connector
(NOT the DB25) and cable equipped with
a RJ12 connector.Configuration using the
PC software, please refer to the software
manual on the CD-ROM.
The PC logic can reduce the number
of module connections. If a Feedback
module is added, this reduction no lon-
ger applies.
GB
and select the menu item.
in order to make the selection.
, the memory is switched on, return to the main
[ MEMORY ]
Set inputs
MEMORY
ON [ >]
M 1 2 3 4 5 6
_ _ _ _ _ _
55